引用本文:
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览次   下载 本文二维码信息
码上扫一扫!
分享到: 微信 更多
考虑水包油乳状液的复合驱数学模型
马德胜, 刘皖露, 王 强, 孙盈盈
(中国石油勘探开发研究院提高石油采收率国家重点实验室,北京 100083)
摘要:
通过考察乳化液在多孔介质中的渗流规律,建立考虑乳化作用的复合驱数学模型。新模型既考虑水包油乳状液的形成可提高驱替相流度的作用,又考虑乳化降低残余油的机制;建立相对渗透率和相黏度的描述方式;将物理模型与数学模型结合,提出模型关键参数的获取方法。结果表明,复合驱中乳化可有效起到降水增油的作用,随着乳化性能增强,其降水增油能力也逐渐提升,但是增加的幅度逐渐减小。
关键词:  乳化  数学模型  复合驱  相对渗透率曲线  残余油
DOI:10.3969/j.issn.1673-5005.2013.06.016
分类号:TE 319 〖HTH〗
基金项目:中国石油天然气股份公司油气田开发重大科技项目(2011B-1306;2011B-1308)
Mathematic model of alkali-surfactant-polymer (ASP) flooding with consideration of oil-in-water emulsion
MA De-sheng, LIU Wan-lu, WANG Qiang, SUN Ying-ying
(Research Institute of Petroleum Exploration and Development, State Key Laboratory of EOR, Beijing 100083, China)
Abstract:
Based on the study on emulsion flow behavior in porous media, a new mathematical model of alkali-surfactant-polymer (ASP) flooding was established. The mechanisms were considered that emulsion can improve the mobility of displacing phase and emulsion also can reduce residual oil saturation in the new model. Accordingly, the description of choosing new relative permeability curve and modifying viscosity of displacing phase after emulsification was established. A laboratory method was proposed to obtain the key parameters of the new model which combined the physical model with the mathematical model. The results show that emulsification of ASP flooding can reduce the water cut and increase oil output effectively. This effectiveness increases with the increase of emulsifiability, but the rate of increase decreases gradually.
Key words:  emulsification  mathematical model  ASP flooding  relative permeability curve  residual oil
版权所有 中国石油大学学报(自然科学版)编辑部 Copyright©2008 All Rights Reserved
主管单位:中华人民共和国教育部 主办单位:中国石油大学(华东)
地址: 青岛市黄岛区长江西路66号中国石油大学期刊社 邮编:266580 电话:0532-86983553 E-mail: journal@upc.edu.cn
本系统由:北京勤云科技发展有限公司设计