引用本文:
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览次   下载 本文二维码信息
码上扫一扫!
分享到: 微信 更多
中等强度砂岩饱水力学参数变化试验及动态出砂规律
董长银, 周崇, 钟奕昕, 王鹏, 崔明月, 曾思睿, 尚校森1,2
1. 中国石油大学石油工程学院, 山东青岛 266580;2. 中国石油勘探开发研究院, 北京 100083
摘要:
为了研究含水条件变化对砂岩储层出砂的定量影响规律,对国外某油田N储层中等强度砂岩27块岩心进行不同饱水时间和饱水度条件下的三轴强度破坏试验,测试不同围压三轴破坏强度、弹性模量、泊松比以及内聚力、内摩擦角随饱水时间和饱水度的变化。试验揭示中等强度砂岩力学参数随饱水度的变化规律。根据试验数据,利用极限稳定强度指数模型拟合岩心力学强度参数随饱水时间和饱水度的变化经验关系式,用于该储层的动态出砂临界条件预测。结果表明:在饱水时间为0~50 d内,不同围压下的三轴破坏强度、弹性模量随着饱水时间明显下降,饱水50 d时围压40 MPa下的破坏强度和弹性模量均下降约30%;随着饱水度从0增加到100%,岩心三轴破坏强度、内聚力和弹性模量先降低较快,然后趋于稳定,最终无量纲强度比约为72%;该储层含水饱和度上升至0.85时,储层出砂临界压差下降25%~30%,而地层压力下降30%情况下,出砂临界压差降低10%~11%;未来含水上升和地层压力下降是导致该储层出砂的主要诱发条件。
关键词:  中等强度砂岩  饱水度  饱水时间  力学强度参数  三轴破坏试验  动态出砂预测
DOI:10.3969/j.issn.1673-5005.2017.06.013
分类号:
基金项目:国家自然科学基金项目(51374226,51774307);国家重点研发计划项目(2017YFC0307304)
Experimental study on mechanical properties of medium strength sandstone saturated with water and its dynamic sanding behaviors
DONG Changyin, ZHOU Chong, ZHONG Yixin, WANG Peng, CUI Mingyue, ZENG Sirui, SHANG Xiaosen1,2
1. School of Petroleum Engineering in China University of Petroleum, Qingdao 266580, China;2. Petroleum Exploration and Development Research Institute, PetroChina, Beijing 100083, China
Abstract:
In order to quantify the effect of water saturation on sand production, a series of core tri-axial testing was performed using 27 cores from a medium strength sandstone reservoir in an oilfield abroad, in which different water saturating time and water saturation at various surrounding pressure were applied for the measurement and analysis of the failure strength, elastic modulus, Poisson ratio, cohesive force and internal friction angle of the rock samples. The variations of rock strength at different water saturation conditions were revealed in the experiments. Based on the experimental data, an empirical ultimate strength exponential model was fitted to quantify the relationship of rock strength and water saturating conditions. The results indicate that the failure strength of the rock samples and elastic modulus decrease obviously with water saturating time varying from 0 to 50 d, and can drop to 70% of their initial value under water saturating time of 50 d and surrounding pressure of 40 MPa. With water saturation changing from 0 to 100%, the compressing failure strength, elastic modulus and cohesive force decrease dramatically at the early stage, then slowly to a stable state, the final dimensionless strength ratio of which is about 72%. The empirical model can be further used for the prediction of dynamic sanding behaviors. The increasing water saturation to 0.85 can cause a reduction of the critical sanding pressure drawdown (CSPD) by 25%-30%. Meanwhile, a 30% reduction of the reservoir pressure can lead to 10%-11% decreasing of the CSPD. The increase of water saturation and reduction of reservoir pressure in the Iraq reservoir studied can be the main inducing conditions for sand production in the process of future production.
Key words:  medium strength sandstone  water saturation  water saturating time  rock mechanical parameters  tri-axial failure test  dynamic sanding prediction
版权所有 中国石油大学学报(自然科学版)编辑部 Copyright©2008 All Rights Reserved
主管单位:中华人民共和国教育部 主办单位:中国石油大学(华东)
地址: 青岛市黄岛区长江西路66号中国石油大学期刊社 邮编:266580 电话:0532-86983553 E-mail: journal@upc.edu.cn
本系统由:北京勤云科技发展有限公司设计